Roland AT900C - Manual (Page 178)

176
Recording/Playing Back What You Play
In this method, each part (track button) is recorded one after
another: first the Rhythm part, then the bass part, etc. If there
are any previously recorded performances, you can listen to
them as you record additional parts.
1. Select the panel settings needed for recording
the performance.
2. Touch on the Main screen.
The Rec/Play screen appears.
fig.07-04-2.eps
3. Touch the and buttons to select
the desired measure (bar) when you start
recording.
If you wish to start recording from the beginning of the
song, touch the button.
4. In the Rec/Play screen, touch to enter
recording-standby mode.
and the unrecorded track buttons in the screen
will blink. The track buttons that are already recorded
will light.
fig.07-15.eps
Also, the panel Composer [Rec] button indicator will
light, and [Play/Stop] button will blink.
You can also enter recording-standby mode by pressing the
Composer [Rec] button.
5. In the Rec/Play screen, touch to begin
recording.
When you touch in the Rec/Play screen, the
metronome will sound a two-measure count, and then
recording will begin.
As you listen to the performance song previously
recorded, record the Part into a new Track.
You can also start recording by pressing the Composer
[Play/Stop] button.
6. In the Rec/Play screen, touch to stop
recording.
The track button for which performance data has been
recorded will be lit.
You can also stop recording by pressing the Composer
[Play/Stop] button.
7. Repeat steps 3–6 to record each part.
Recording Each Part Separately
blink
AT-900_e.book 176 ページ ２００７年９月７日 金曜日 午前８時４３分