Radio Shack 43-3704 - Manual (Page 74)

N
ote about H
andse
t-Base Registr
ation
74
NOTE ABOUT HANDSET-BASE
REGISTRATION
When you register the handset with the base, unique data is written on
both the base and the handset. The handset registered to one base unit
cannot be used with other base unit unless the registration data is “de-
registered” with the original base unit. This means the handset must be
within the range of the original base unit to de-register. If for any reason
the original base unit is not within the range (or the registration data in
the original base unit is erased), “Out of Range” error takes place and
you cannot de-register the handset.
Should you encounter this trouble, follow these steps to individually de-
register the handset and the base.
1. Remove the handset if it sits on the base.
2. On the handset, press and hold
END and # at the same time until you
hear beep.
3. Disconnect the AC adapter.
4. While holding
PAGE , connect the AC adapter. Keep pressing PAGE
until the CHARGE LED starts to blink.
5. Place the handset on the base and wait until the CHARGE LED
stops flashing.
This erases all the handset registration data on the base, not limited to
the handset you placed at Step 5 above. You need to register other
handset(s) also if you have more than one. First de-register the handset
as in Step 1 above, and then place it on the base.
If you have trouble in de-registration, take your base and handset
(including extra handset(s) if you have) to your local RadioShack or call
1-800-The Shack (843-7422) for assistance.
Also, when you request repair or service, please be sure to bring in the
entire system (including extra handset if used) so we can keep your
registration data intact.