Radio Shack 43-3704 - Manual (Page 29)

Setting Menu Options
29
2. Press CID/VOL/ or REDIAL/P/ to
select Line1 or Line2 , and then press
the OK soft key.
3. Press the number keypad ( 0 - 9 ) to enter
a 3-digit area code.
4. Press the OK soft key. You will hear a
confirmation tone.
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most
phone systems use tone dialing; the default
setting is tone dialing. Set the dialing mode
to match the dialing system used by your
local phone service.
• If you are not sure of your dialing
system, set the unit to tone dialing.
Make a trial call. If the call connects,
leave the setting as is; otherwise set
the unit to pulse dialing.
• If your phone system requires pulse
dialing and you need to send DTMF
tones in certain situations during a call,
you may switch over to tone dialing
(refer to “Tone Dialing Switch Over” on
page 35).
1. Press the MENU soft key. Select the
Global Setup menu, and then the Dial
Mode submenu.
2. Press CID/VOL/ or REDIAL/P/ to
select Line1 or Line2 , and then press
the OK soft key.
3. Press CID/VOL/ or REDIAL/P/ to
select Tone or Pulse (the initial
setting is Tone).
4. Press the OK soft key. You will hear a
confirmation tone.