Radio Shack 43-3704 - Manual (Page 58)

The
Integrat
ed Answ
ering Device
58
8. Press SKIP/SELECT or
REPEAT/SELECT until you hear the
correct AM or PM setting.
The message counter displays
A or P .
9. Press SET to select the AM/PM setting.
A confirmation tone sounds, the day
and time you set are announced for
your review.
Setting a PIN code
To play your messages from a remote
location, you will need to enter a two-digit
Personal Identification Number (PIN) code.
To select a PIN code, perform the following
steps: Ô
1. Press L1 ANSWER or L2 ANSWER .
2. Press CLOCK/MENU once. The current
PIN code appears on the base and it is
announced.
3. Press SKIP/SELECT or
REPEAT/SELECT until the desired
number appears. Press and hold
SKIP/SELECT or REPEAT/SELECT
to quickly scroll through the numbers
on the display.
4. Press SET to select the PIN code.
A confirmation tone sounds, the system
announces the new PIN code.
Setting the ring time
The ring time setting allows you to set the
number of rings the caller hears before your
answering system plays the outgoing
message. You can set the ring time to
answer after two, four, or six rings. Setting
“TS” (Toll Saver), the answering system
picks up after two rings if you have new
messages, and after four rings if there are
none. This way, if you make a long distance
Ô
NOTES
Ô
• To scroll through the
menu options,
repeatedly press
CLOCK/MENU on the
base in standby mode.
The system returns to
standby after the last
menu option.
• When you have
completed the setting,
press !PLAY/
" STOP
to exit the menu mode,
or CLOCK/MENU to
move to the next menu
option.