Radio Shack 43-3704 - Manual (Page 67)

The
Integrate
d Answ
ering Device
67
A confirmation tone, that can be heard
by both parties, sounds during
recording.
3. To stop recording, press the MENU soft
key and CID/VOL/ or REDIAL/P/ to
select Call Record , and then press
the OK soft key. You will hear a
confirmation tone.
R
EMOTE
O
PERATION
You can check, play, or delete messages,
even record a new greeting message from a
remote location (when you are away from
home, or from another room using a
handset). Additionally, you can turn On or
Off your answering system remotely. Ô
Remote access away from home
You can operate your answering system
from a remote location using any
touch-tone telephone. Ô
1. Call your telephone number and wait
for the system to answer. If the
answering system is off, it will answer
after about ten rings and sounds a
series of beeps.
2. During the greeting message (or a
series of beeps when the answering
system is off), press 0 and enter your
PIN code within two seconds (see
“Setting a PIN Code” on page 24 or 58).
3. The answering system announces the
current time and the number of
messages stored in memory. You hear
“To play incoming messages, press
zero-two. For help, press one-zero”.
You will hear a beep.
Ô
NOTES
Ô
Remote Operation
Time stamp will not be
heard until you have set the
time. See “Setting the Time”
on page 57.
Remote access away
from home
• The system will only
playback messages for
four minutes and then it
returns to the command
waiting mode. To
continue playing your
messages, press 0 then
2 again within 15
seconds.
• If you enter an incorrect
PIN code three times,
you will hear a beep and
the system will return to
standby.
• During the remote
operation,
“Lr” appears on the
base.
• If the answering system
is recording an incoming
message, the recording
operation is canceled
when you start remote
operation.