Radio Shack 43-3704 - Manual (Page 39)

Phonebook
39
5. Press the number keypad to enter the
phone number (up to 20 digits), press
the
OK soft key to store the number. Ô
6. Distinctive Ring appears. Press
CID/VOL/ or REDIAL/P/ to move the
pointer to one of the Distinctive Ring
options, and then press the
OK soft key.
Ô
7. Speed Dial appears. Press
CID/VOL/ or REDIAL/P/ to move the
pointer to select the Speed dial location
(ten locations: SPD1-SPD0). Ô
8. Press the OK soft key. You will hear a
confirmation tone, and Done! appears
in the display.
S
TEPS FOR
E
NTERING
N
AMES
AND
S
PECIAL
C
HARACTERS
Refer to the letters on the number keys to
select the desired characters. With each
press of a number key ( 0 - 9 ), the displayed
character appears in the following order:
upper case letters first, lower case letters
next and finally the number corresponding
to the key. Ф
Ф
NOTES
Ô
• The pause key counts as
one digit. Pressing
REDIAL/P/ more than
once increases the
length of the pause
between numbers. Each
pause represents a two
second delay.
• If you choose not to
store a “Distinctive
Ring”, simply select the
“No Selectn” option.
• Selecting a speed dial
location where a number
is already stored,
releases the old
number’s speed dial
setting. The new number
will be stored in the
speed dial location.
• If you choose not to
store the name/number
as a Speed Dial, simply
select the “No Selectn”
option.
• If the next character
uses the same number
key, you must press #/>
to move the cursor over.
Otherwise the next time
you press the number
key, it changes the
character that was
previously set.