Regency G36D - Manual (Page 24)

UltraGlow ® G36D Zero Clearance Direct Vent Gas Fireplace ® ® 24
CONVERSION KIT #773-969 FROM NG TO LPG
FOR G36D-1 USING SIT 820 NOVA GAS VALVE
INSTALLATION
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
1) Shut off the gas supply Shut of Shut of .
2) Remove the louvers (and bay door if it is
installed).
3) Open the fl ush door and remove the
door.
4) Remove the logs and embers.
5) Remove the 2 screws holding the Burner
Assembly to the firebox base. Push the
Burner Assembly to the left and lift out.
6) Pull off the pilot cap to expose the pilot Pull of Pull of
orifice.
Burner Orifice
7) Unscrew the pilot orifice with the allen
key and replace with the LP pilot orifice
in the kit and replace pilot cap.
Remove the 2 screws, push Burner
Assembly to the left and lift out.
10) Turn control knob to the “OFF” position.
11) Remove the black protection cap by
hand from the high-low knob (Fig.1).
12) Insert a 5/32” or 4mm Allen wrench into
the hexagonal key-way of the screw
(Fig. 2), rotate it counter-clockwise until
it is free and extract it.
13) Check that the screw is clean and if
necessary remove dirt.
14) Flip the screw (Fig. 3).
Fig. 1
Fig.2
8) Remove burner orifice with a 1/2"
wrench and discard. Use another wrench
to hold on to the elbow behind the
orifice.
9) Reinstall new burner orifice LP stamped
#53 and tighten.
Each Kit contains one LPG
Conversion Kit and one DC
Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part #
Description
1 904-345 Burner Orifice #53
1 908-528 Red "LPG" label
1 908-255 Label "Converted to
LPG"
1 908-529 5/32" Allen Key
1 910-037 LP Injector (Pilot Orifice)
1 918-476 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part # Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
1 904-438 Plug Nylon 0.750 Hole,
Black
2 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4 Pan
Head
2 904-553 Screw #8 x 1/2 Type "B",
Black Oxide
1 910-073 Spark Generator Battery
Holder
1 910-074 Spark Generator Switch
C/W Wire
1 910-078 Battery Size AA
Energizer En91
1 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
1 910-480 Instruction Sheet
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
Installation of LPG
Conversion Kit:
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!