Installation, Venting – Regency G36D User Manual

Page 11

UltraGlow

G36D Zero Clearance Direct Vent Gas Fireplace

VENTING

UltraGlow

UltraGlow Direct Vent System (Flex)

Horizontal Terminations Only

These venting systems, in combination with the G36D Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by

Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in the "Exterior Vent

Termination Locations" section.

UltraGlow

UltraGlow Direct Vent Flex Termination Kit (Part # 946-515) includes all the parts

needed to install the G36D with a maximum total run of 4 feet.

INSTALLATION

Notes:

1) Liner sections should be continuous without any joints or seams.

2) Only Flex pipe purchased from Regency

may be used for Flex installations.

1) 6-7/8" dia. ﬂ exible liner (4 ft. length)

2) 4" dia. ﬂ exible liner (4 ft. length)

3) spring spacers (4)

4) thimble (2)

5) AstroCap termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point, Stainless Steel (4)