Renesas Emulation Pod for M16C/80 Group MCUs M30803T-RPD-E - Manual (Page 29)

( 27 / 74 )
Table 3.2 Switch settings of the M30803T-RPD-E (2/3)
Signal Switch Setting Description
CNV
SS
SW5
SW6 BYTE
A-D input
Select group
SW7
Pulls down the CNV
SS
pin with a resistance of 33
k Ω (when target system is unconnected and using
in single-chip mode or memory expansion mode).
Be sure to set this when using the emulation pod
while not connecting the target system.
Connects the CNV
SS
pin to the target system.
Pulls up the CNV
SS
pin with a resistance of 33 k Ω
(when target system is unconnected and using in
microprocessor mode).
Be sure to set this when using the emulation pod
while not connecting the target system.
Connects the BYTE pin to the target system.
Pulls up the BYTE pin with a resistance of 33 k Ω
(when target system is unconnected and using in
8-bit bus mode).
Be sure to set this when using the emulation pod
while not connecting the target system.
Set when not using the A-D input group selection
function. Use this product with this setting.
Set when using the A-D input group selection
function. This product cannot be used with this
setting.
Pulls down the BYTE pin with a resistance of 33 k Ω
(when target system is unconnected and using in
16-bit bus mode).
Be sure to set this when using the emulation pod
while not connecting the target system.