RCA Satellite System - Manual (Page 53)

51
Mounting the Mast
Mounting on Brick or Poured Concrete
Materials Needed to Mount the Mast on Brick
or Poured Concrete:
(4) B4015 or equivalent double-expansion anchors
(4) #20, 1/4" x 3" machine screws
(4) 5/16" flat washers
Tools Needed to Mount the Mast on Brick
or Poured Concrete:
electric drill with 1/2" masonry bit
bubble level
screwdriver
hammer
7/16" wrench
pencil
Important Considerations:
• Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
4 B4015 or equivalent
double expansion anchors
4 #20, 1 / 4 x 3"
machine screws
4 5 / 16 " washers
DANGER! AVOID Power Lines!
When following these instructions, take extreme care to avoid
contact with overhead power lines, electric lights, and power
circuits. Contact with power lines, electric lights, or power
circuits may be fatal. It is recommended that the dish be
located more than 20 feet from overhead power lines.
IMPORTANT
The wall anchors used must have a
strength of at least 300 pounds of
pull-out pressure. B4015 or
equivalent double-expansion anchors
are recommended.