RCA Satellite System - Manual (Page 18)

16
Some Indoor Stuff
Connection C
Good Picture and Sound Quality
To use this connection you must have:
• TV with RF input (jack)
• VCR with RF and audio/video inputs
• Coaxial and audio/video cables
To connect TV, VCR, and antenna or cable box.
1. Connect coaxial cables and audio/video cables as shown.
To receive DSS ® programming:
• Tune TV to channel 3 or 4 (depending on how you set the
CH3/CH4 switch on the back of the receiver).
To receive off-air programming (no cable box):
1. Turn off VCR and DSS ® receiver.
2. Tune TV to desired channel.
To receive cable programming (with cable box):
1. Turn off VCR and DSS ® receiver.
2. Tune TV to cable box output channel (usually CH2, CH3, or
CH4).
3. Tune cable box to desired channel.
To record DSS ® programming:
1. Tune TV to the channel on which you receive the DSS ® signal.
2. Tune DSS ® receiver to desired channel.
3. Set VCR to record on line input.
To view VCR programming:
1. Tune TV to VCR output channel (usually CH3 or CH4).
2. Turn DSS ® receiver off.
Cables needed for this connection:
three (3) audio/video cables. You must
use RG-6 coaxial cable from the DSS
®
dish to the Satellite In jack on the
DSS
® receiver. For best picture quality,
use RG-6 coaxial cable with all coaxial
cable connections.