RCA Satellite System - Manual (Page 49)

47
Mounting the Mast
Mounting on Lap Siding
Materials Needed to Mount the Mast on Lap Siding
(2) 5/16" x 3" lag screws
(4) 5/16" x 2" lag screws
(4) 5/16" washers
Tools Needed to Mount the Mast on Lap Siding:
electric drill with 1/8" and 3/16" wood bits
bubble level
1/2" wrench
3/8" wrench
7/16" wrench
pencil
Important Considerations:
• Do NOT mount the DSS ® dish on any type of aluminum or
vinyl siding.
• Do NOT mount the dish on any type of composite paneling,
such as fiber board, particle board, or strand board.
• Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
2 1 / 4 x 3" lag screws
4 5 / 16 x 2" lag screws
4 5 / 16 " washers
Two (2) 5/16" x 3" lag screws
Four (4) 5/16" x 2" lag screws
Four (4) 5/16" washers
DANGER! AVOID Power Lines!
When following these instructions, take extreme care to avoid
contact with overhead power lines, electric lights, and power
circuits. Contact with power lines, electric lights, or power
circuits may be fatal. It is recommended that the dish be
located more than 20 feet from overhead power lines.