RCA Satellite System - Manual (Page 55)

53
Mounting the Mast
Mounting On a Hollow or Cinder
Block Wall
Materials Needed to Mount the Mast on a Hollow or
Cinder Block Wall:
(4) 1/4" hollow wall togglers
(4) #20, 1/4" x 3" machine screws
(4) 4/16" flat washers
Tools Needed to Mount the Mast on a Hollow or
Cinder Block Wall:
electric drill with 1/2" masonry bit
bubble level
screwdriver
7/16" wrench
pencil
Important Considerations:
• Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
4 1 / 4 " hollow wall togg
4 #20, 1 / 4 x 3"
machine screws
4 5 / 16 " washers
DANGER! AVOID Power Lines!
When following these instructions, take extreme care to avoid
contact with overhead power lines, electric lights, and power
circuits. Contact with power lines, electric lights, or power
circuits may be fatal. It is recommended that the dish be
located more than 20 feet from overhead power lines.