NEC EXPRESS 320Lb-R - Manual (Page 233)

Troubleshooting 7-33
Problems with NEC EXPRESSBUILDER
When the server is not booted from the NEC EXPRESSBUILDER CD-ROM, check the following:
Did you set the NEC EXPRESSBUILDER CD-ROM during POST and restart the
server?
→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST and
restart the server, an error message will appear or the OS will boot.
Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the server.
Use the BIOS setup utility to change the boot device order to boot the system
from the CD-ROM drive first.
When an error occurs while the NEC EXPRESSBUILDER is in progress, the following message
appears. After this message appears, check the error and take the appropriate corrective action
according to the error codes listed in the table below.
Message Cause and Remedy
This machine is not supported. This NEC EXPRESSBUILDER version is
not designed for this server. Execute the
NEC EXPRESSBUILDER on the compliant
server.
NvRAM access error An access to the nonvolatile memory
(NvRAM) is not acceptable.
Hard disk access error The hard disk is not connected or it is
failed.
Check whether the hard disk is correctly
connected.
An error message will also be displayed when an error was detected during system diagnosis. Take a
note or print the error message displayed, and contact your sales agent.