NEC EXPRESS 320Lb-R - Manual (Page 148)

5-22 Installing and Using Utilities
When [ft Server] Tree Appears on a Data Viewer in an Incorrect Manner
If you perform a Data Viewer startup or tree rebuilding just after the system starts up or after the
PCI module starts up/shuts down, the [Ft Server] tree side may not appear normally on the Data
Viewer. In this case, wait for 5 minutes before retrying a Data Viewer startup.
Information Displayed on a Data Viewer
Some information of the devices cannot be acquired due to the OS specifications. These devices are
displayed as “Unknown” on the Data Viewer of the NEC ESMPRO Manager. Also, accurate
information may not be acquired due to the OS specifications. In such case, accurate information
may not be displayed.
Mirror Information of the SCSI Disk
The “Mirror disk” displayed on the [Ft Server] tree of the Data Viewer is always in gray. Also,
“Unknown” is always displayed on the “Status” field.
Stopping the PCI Module by the ft server utility
When you stop the PCI module on the primary side by the ft server utility, the ft server utility screen
may become blur temporarily. However, it returns to a normal status after a few seconds when the
pop-up screen is displayed on the ft server utility. This will not cause a problem for the ft server
utility functions.
About the display of a floppy disk drive
When a USB floppy disk drive is connected, the information on a floppy disk drive is not displayed
on a data viewer.