If the in-skin router does not start, If the alarm lamp on the pn-rta card is lit, If none of the lamps on the pn-rta card is lit – NEC NEAX IPS NWA-008869-001 User Manual
Page 171: If the boot monitor mode screen is displayed
CHAPTER 7 TROUBLESHOOTING
– 161 –
NWA-008869-001 Rev.1.0
atch7001.fm
IF THE IN-SKIN ROUTER DOES NOT START
If the In-Skin Router does not start, check the following and take the appropriate action.
If the ALARM lamp on the PN-RTA card is lit
If it is lit, check the installation environment for the In-Skin Router (including the temperature and humid-
ity). If it is lit even when the installation environment is proper, replace the PN-RTA card.
If none of the lamps on the PN-RTA card is lit
Check that the power cord is connected properly and that the power switch is turned ON of PN-RTA card
and the system. If none of the lamps is lit after the cord is connected properly and the power switch is
turned ON, replace the PN-RTA card.
If the boot monitor mode screen is displayed
If all the program files in the file system have been deleted or destroyed by accident, the In-Skin Router
cannot start, displaying the boot monitor mode screen shown below.
MEMO:
On the screen, “FastEther” indicates the LAN1 port, while “Ethernet” indicates the LAN2 port.
If this occurs, you can use the TFTP boot function to transfer the necessary program files from
the TFTP server and start the In-Skin Router.
Device types available:
Ethernet
FastEther
Device type:
IF THE IN-SKIN ROUTER DOES NOT START