NEC NEAX IPS NWA-008869-001 - Manual (Page 165)

CHAPTER 6 MANAGEMENT AND MAINTENANCE
– 155 – NWA-008869-001 Rev.1.0
atch6001.fm
(4) Turning ON the power switch to start the device
Turn ON the power switch (PWRSW). Check that a message indicating that startup config has been
erased is displayed on the local console and a prompt is then displayed.
NOTE: Never turn OFF the power switch until a prompt is displayed. Otherwise, the contents of flash
memory may be destroyed.
(5) Turning OFF the power switch
Turn OFF the power switch (PWRSW) to stop the In-Skin Router.
IX1000 Series Router POST (Power On Self Test)
DRAM TEST 1 : Pass
DRAM TEST 2 : Pass
NVRAM TEST : Pass
CPU TEST : Pass
PLD TEST : Pass
LAN1 TEST : Pass
LAN2 TEST : Pass
VOLTAGE : 3.199V Pass
TEMPERATURE : +32.0degC Pass
Config memory is cleared
Copyright (C) NEC Corporation 2001. All rights reserved.
Copyright (C) 1985
− 1998 OpenROUTE Networks, Inc.
Copyright (C) 1995
− 1998 Eric Young
No valid boot records found, attempting flash load
Loading using Flash Load Image "ix1000 − ms − 4.0.5.ldc"
(Omitted)
Router #
Check that config
has been cleared.
SUPER RESET