NEC NEAX IPS NWA-008869-001 - Manual (Page 162)

CHAPTER 6 MANAGEMENT AND MAINTENANCE
– 152 – NWA-008869-001 Rev.1.0
atch6001.fm
RESTARTING THE IN-SKIN ROUTER DURING OPERATION
If you need to restart the In-Skin Router during operation for some reason or other, three methods are avail-
able. Each differs in startup operation; perform the restart suitable to your need.
Restarting by turning the power switch OFF and back ON
The restart with this method involves self-diagnosis, program loading, the loading of startup config, and
the clearing of DRAM.
Restarting procedure
Check that the BUSY lamp is not flashing, then turn OFF the power switch of PN-RTA card (PWRSW) to
stop the In-Skin Router. In a few seconds, turn ON the power switch again to restart the In-Skin Router.
Restarting with the reload command
The restart with this method involves program loading, the loading of startup config, and the clearing of
DRAM.
Restarting procedure
Use the reload command in operation mode.
Router # reload
Are you sure you want to reload the router? (Yes or [No]) : y
Copyright (C) NEC Corporation 2001. All rights reserved.
Copyright (C) 1985 − 1998 OpenROUTE Networks, Inc.
Copyright (C) 1995 − 1998 Eric Young
No valid boot records found, attempting flash load
Loading using Flash Load Image "ix1000
− ms − 4.0.5.ldc"
------------------
Starting at 20000
NEC Portable Internetwork Core Operating System Software
(Omitted)
Router #
Enter
Enter
RESTARTING THE IN-SKIN ROUTER DURING OPERATION