NEC NEAX IPS NWA-008869-001 - Manual (Page 127)

CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
– 117 – NWA-008869-001 Rev.1.0
atch5001.fm
Setting a static route
Setting
Directly specify the diversion location of a packet destined to a particular network (or host address).
In this example, a static route is set as follows: because the diversion location of a packet destined to net-
work B “192.168.1.0/24” on which terminal B is located is the address “192.168.3.1” of the router on net-
work A.
MEMO: To set the address “192.168.3.1” as the default route, perform the following:
Checking
Use the show ip route command to check the settings.
Router # enable
− config
Router (config) # ip route 192.168.1.0/24 192.168.3.1
Router (config) #
Enter
Enter
Router # enable
− config
Router (config) # ip route default 192.168.3.1
Router (config) #
Enter
Enter
Router (config) # show ip route
IP Routeing Table − 3 entry
Codes : C − Connected, S − Static, R Ð RIP, * − Candidate default
Timers : Age
S 192.168.1.0/24 [1/1] via 192.168.3.1, Ethernet0.0, 0 : 00 : 01
C 192.168.2.0/24 [0/1] is directly connected, FastEthernet0.0, 0 : 00 : 22
C 192.168.3.0/24 [0/1] is directly connected, Ethernet0.0, 0 : 00 : 01
Router (config) #
Enter
ROUTING SETUP EXAMPLES (IPv4)