Nortel Networks Server 600r - Manual (Page 39)

39
Chapter 5
Connecting the server to power
In this chapter
"Safety precautions" (page 39)
"Locating the power supply modules" (page 39)
"Connecting the server to power" (page 40)
Safety precautions
Equipment handling guidelines
External power equipment, such as an Uninterruptible Power Supply
(UPS), is usually very heavy. This equipment requires special handling
procedures and additional personnel for unloading and installation. Be
aware of weight distribution, and prevent the equipment room floor from
being overly stressed.
Safety information
DANGER
Procedures involving electrical connections must be performed
only by qualified personnel. Ensure that you obey all displayed
warning notices on power equipment and connections.
Locating the power supply modules
Introduction
The AC power supply module is shipped installed. The following diagram
shows the location of the power supply module in the back panel (E).
Note: Nortel provides only AC power supply. The server works with a
DC-to-AC converter, however, you must ensure the converter meets
Nortel CallPilot
600r Server Hardware Installation
NN44200-307 01.03 Standard
5.0 14 May 2008
Copyright © 2007-2008, Nortel Networks
.