Nortel Networks Server 600r - Manual (Page 29)

Connecting peripherals to the server 29
Figure 7
Rear panel
Table 4
Rear panel connectors
Label Description Label Description
A USB 0, USB 1, USB 2
(labelled 0, 1, 2 on server) G Ground studs (used with system with DC input
power supply)
B PS/2 Mouse H RJ45 NIC 2 ELAN connector (labelled 2 on
server)
C SCSI port I RJ45 NIC 1 CLAN connector (labelled 1 on
server)
D PCI card bracket (full-height)
for MPB96 J Video connector
E Power supply K COM1 DB-9 serial port
F AC power input L PS/2 Keyboard connector
To connect the mouse, keyboard, and monitor to the server
Step Action
1 Place the monitor, keyboard, and mouse in the same location as
the server.
2 Plug the keyboard and mouse into the appropriate PS/2 connectors
on the chassis rear panel. See labels L and B, respectively, on the
diagram.
3 Plug in the monitor connector (see diagram, label J). Tighten the
screws on the connector.
4 Connect the power cord to the monitor and plug the other end into
a wall receptacle or power bar.
5 Turn on the monitor.
—End—
Nortel CallPilot
600r Server Hardware Installation
NN44200-307 01.03 Standard
5.0 14 May 2008
Copyright © 2007-2008, Nortel Networks
.