NEC SILENTWRIT 1700 Series - Manual (Page 98)

5–10 1765 Network Printer Configuration Guide
Setting the TCP/IP Auto IP Address
If Auto IP is on, you can use the UNIX commands arp
and ping to change the LAN card's IP address. Arp is a
host command which displays or modifies the host's
ARP entry table to assign a MAC address to a known IP
address. Follow these steps to set Auto IP to On.
1.
Select the printer you want to change from the list of
printers in the Printer Administration window.
2. From the Printer Administration window click the
TCP/IP
button or select the TCP/IP menu option
from the Configure menu.
3. Set the Auto IP Address radio button to On.
4. Select the Save button to save the new auto IP
address selection method and leave the TCP/IP
Parameters dialog box
Or
Select the Cancel button to keep the old auto IP
address selection method and leave the TCP/IP
Parameters dialog box.
note: If your network does not support arp ,
changing the Auto IP Address setting has no effect.
Follow these steps to change the LAN card's IP address
using Auto IP. You will need to know the host's IP
address, the LAN card's old IP address, and the new IP
address for the LAN card. Your system administrator
will know the old IP address. Print a configuration page
to see the LAN card’s IP address. See “Print a
Configuration Page” on page 2-13.
note: Turn off any other Silentwriters with the same
IP address before following these steps.
1. Open the command prompt window.
2. Use the route command to add the LAN card's IP
address to the ARP table.
route add
For example,
route add 11.22.33.44 11.22.33.51
Some operating systems require a 0 at the end of the
route add command. Check with your system
administrator.
3. Use the ping command to get the target LAN card
information. Be sure to turn off any other
Silentwriters with the same IP address first.
ping
For example,
ping 11.22.33.44
4. Use the arp command to get the LAN card's MAC
address.
arp -a
The LAN card's MAC address will be displayed.
Interface:
Internet Address Physical Address Type
dynamic
For example,
Interface: 11.22.33.51
Internet Physical
Address Type
11.22.33.44 00-a0-92-01-56-26 dynamic