Nortel Networks Passport 4400 User Manual
Page 57
Connecting the Expansion Modules
Passport 4400 Hardware Installation Manual
4-11
Procedure 10: Terminal block connection
1.
Remove the plug from the terminal block.
2.
Use a cable (not supplied) with bare-wire leads. Insert each cable lead into
the cutout at the front of the plug and secure it with a small flathead
screwdriver at the top. It is recommended that the cable leads be color coded
for easy identification.
3.
Insert the plug that now includes the cable leads in the terminal block.
4.
After the connection is made, install the connector cover by inserting the
right tab of the cover in the retaining slot of the interface module back
panel. Secure on the left side with a Phillips-head screw.
For further information about cables and pin assignments, see Appendix A, “Cable
Diagram Pin Assignments.”