Nortel Networks Passport 4400 - Manual (Page 50)

Connecting the Expansion Modules Passport 4400 Hardware Installation Manual
4-4
Procedure 5: Connecting the Legacy Data Module
Note: The connections made in this procedure will depend on the
specific site requirements. If you are not sure of the exact
connections required for the Passport 4400 unit, consult your
system administrator.
1. If required, use a DB50 cable to connect each MD50 port to your local
equipment.
2. If required, connect the management port using an RJ45 cable.
3. If requires, connect the token ring serial interface using a DB9 cable.
Procedure 6: Connecting the Legacy Data Expansion Module
Note: The connections made in this procedure will depend on the
specific site requirements. If you are not sure of the exact
connections required for the Passport 4400 unit, consult your
system administrator.
1. If required, use a DB50 cable to connect each MD50 port to your local
equipment.
For further information about cables and pin assignments, see Appendix A, “Cable
Diagram Pin Assignments.”