Nortel Networks Server 1005r - Manual (Page 27)

Removing the front bezel 27
Removing the front bezel
Introduction
To access the hard drives on the front panel, you must remove the front
bezel.
The front bezel covers the electrostatic discharge (ESD) connection, both
hard drives, and the DVD/CD/CDRW drive pull handle. The control panel,
USB port 2, and the front comm 2 serial port connection are not covered by
the front bezel.
To remove the front bezel
Step Action
CAUTION
Risk of equipment damage
Do not attempt to move or lift the server before removing the front
bezel; the server can disengage from the bezel and fall.
1 Loosen the two black captive fasteners on either side of the front
bezel.
2 Pull the front bezel off the front panel by the captive fasteners.
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.06 Standard
5.0 15 May 2008
Copyright © 2006-2008, Nortel Networks
.