Network Instruments GigaStor 114ff - Manual (Page 36)

Configuring Observer for your WAN device
Chapter 2 Installing Your GigaStor 36
rev. 1
Serial T1/E1 Probe Settings
Table 3 describes fields for a serial T1/E1 connection.
Table 3 Serial T1/E1 probe settings
Setting Explanation
WAN/Frame Relay Type Choose T1 or E1 to match the type of link you are analyzing.
Encapsulation You must set this to match the settings on the frame relay router.
Fractionalized Check if your link is configured for fractionalized operation.
Bandwidth Set to match the bandwidth setting of the link you are analyzing.