Network Instruments GigaStor 114ff - Manual (Page 22)

Connecting Observer to the GigaStor
Chapter 2 Installing Your GigaStor 22
rev. 1
Connecting Observer to the GigaStor
This section assumes you have already installed Observer on your
desktop or laptop. If not, install the software. You can download from
the Network Instruments website.
There are three main tasks to connect Observer to your GigaStor
Q
“Redirecting the GigaStor probe” on page 22
Q
“Probe administration” on page 24
Q
“GigaStor Capture Analysis” on page 29
Redirecting the GigaStor probe
1 Choose Start → All Programs → Observer → Observer. Observer
opens.
2 Select Actions → Redirect Probe (Figure 5).
Figure 5 Remote Probe Administration and Redirection
3 Click New to add the GigaStor to the Probe Administration and
Redirection list. Figure 6 appears.