Network Instruments GigaStor 114ff - Manual (Page 35)

Configuring Observer for your WAN device
Chapter 2 Installing Your GigaStor
35
rev. 1
Digital T1/E1 Probe Settings
To access the probe settings, select the probe, right-click and choose
Probe or Device Settings. Then click the T1/E1 tab (Figure 22).
Figure 22 T1/E1 WAN Probe Settings
Table 2 describes fields in Figure 22.
Table 2 T1/E1 WAN Probe Settings
Setting Explanation
WAN/Frame Relay Type Choose T1 or E1 to match the type of link you are analyzing.
Encapsulation You must set this to match the settings on the frame relay CSU/DSU.
Subprotocol If ATM or LAPB is the selected encapsulation method, you must choose the sub-
projects on the link.
Link 1 and Link 2 Channel Settings (Note that for the link and settings to be activated, you must check the
On check box for that link).
Fractionalized Check if this link is configured for fractionalized operation.
Channel selector check
boxes Choose the channels you want to be included in the analysis.
Include in Util.
Thermometer. Check if you want to include statistics from this link in the Bandwidth Utilization
Thermometer.