National Instruments DAQCard-1200 User Manual

Page 95

Index

I-2

grounded signal sources, 3-8 to 3-9
single-ended connections,

3-11 to 3-13

when to use, 3-8

exceeding maximum input voltage ratings

(warning), 3-4

floating signal sources, 3-6
ground-referenced signal

sources, 3-6 to 3-7

input configurations, 3-7 to 3-14
instrumentation amplifier, 3-5 to 3-6
pins, 3-4
recommended input configurations

(table), 3-7

single-ended connections

floating signal sources (RSE

configuration), 3-11 to 3-12

grounded signal sources (NRSE

configuration), 3-12 to 3-13

purpose and use, 3-11
when to use, 3-11

types of signal sources, 3-6 to 3-7

analog output

circuitry, 4-11
DAC timing, 4-12
polarity

configuration, 2-5 to 2-6
settings (table), 2-5

power-management modes (table), C-1
power-on state, 4-12
signal connections, 3-14
specifications, A-4 to A-5

dynamic characteristics, A-5
output characteristics, A-4
stability, A-5
transfer characteristics, A-4
voltage output, A-5

theory of operation, 4-11 to 4-12

bus interface specifications, A-7

calibration, 5-1 to 5-3

EEPROM storage, 5-1
equipment requirements, 5-2
higher gains, 5-2
overview, 5-1
power-management modes (table), C-2
using the 1200_Calibrate

function, 5-2 to 5-3

CLK signals

general-purpose timing signal

connections, 3-26 to 3-30

timing requirements signals (figure), 3-30

CLKB1 signal (table), 3-4
CLKB2 signal (table), 3-4
common mode signal rejection

considerations, 3-13 to 3-14

configuration

analog input

analog I/O settings (table), 2-3
default settings, 2-3
exceeding maximum ratings

(warning), 2-3

input modes, 2-4 to 2-5
input polarity, 2-3

analog output polarity, 2-5 to 2-6
counter/timers, 2-6
digital I/O, 2-6
PC Card, D-1
typical configuration (figure), 2-2

Counter 0 on 82C53(A) counter/timer, 3-22
Counter 1 on 82C53(A) counter/timer, 3-22
counter/timers

configuration, 2-6
power-management modes (table), C-2
theory of operation, 4-3 to 4-5