National Instruments DAQCard-1200 User Manual

Page 100

Index

I-7

DAQCard-1200 User Manual

pins, 3-4
recommended input configurations

(table), 3-7

single-ended connections

floating signal sources (RSE

configuration), 3-11 to 3-12

grounded signal sources (NRSE

configuration), 3-12 to 3-13

when to use, 3-11

types of signal sources, 3-6 to 3-7

analog output signal connections, 3-14
DAQ and general-purpose timing signal

connections

data acquisition timing

connections, 3-22 to 3-26

general-purpose timing

connections, 3-26 to 3-30

pins, 3-22
power connections, 3-31

digital I/O signal connections

illustration, 3-16
pins, 3-15
Port C pin connections, 3-17
timing specifications, 3-18 to 3-21

mode 1 input timing, 3-19
mode 1 output timing, 3-20
mode 2 bidirectional

timing, 3-20 to 3-21

I/O connector

exceeding maximum ratings

(warning), 3-1

pin assignments (figure), 3-2

signal descriptions (table), 3-3 to 3-4

signal descriptions, 3-3 to 3-4
single-ended connections

floating signal sources (RSE

configuration), 3-11 to 3-12

ground-referenced signal sources (NRSE

configuration), 3-12 to 3-13

when to use, 3-11

software programming choices, 1-2 to 1-4

LabVIEW and LabWindows/CVI, 1-3
NI-DAQ driver software, 1-3 to 1-4
register-level programming, 1-4

software-related resources, E-2
specifications

analog input, A-1 to A-4

amplifier characteristics, A-2 to A-3
dynamic characteristics, A-3
input characteristics, A-1 to A-2
stability, A-4
transfer characteristics, A-2

analog output, A-4 to A-5

dynamic characteristics, A-5
output characteristics, A-4
stability, A-5
transfer characteristics, A-4
voltage output, A-5

bus interface, A-7
digital I/O, A-5 to A-6
environment, A-8
physical, A-7
power requirements, A-7
timing I/O, A-6 to A-7

square wave generation, 3-27
stability

analog input specifications, A-4
analog output specifications, A-5

STB* signal (table), 3-18

technical support resources, E-1 to E-2
theory of operation

analog input, 4-5 to 4-8

circuitry, 4-6 to 4-8
data acquisition rates, 4-9 to 4-10
data acquisition timing, 4-8 to 4-9