Paradyne 3162 DSU/CSU - Manual (Page 40)

Operation
3-16 3162-A2-GB20-30 March 1999
Configuring the DSU/CSU for SNMP or Telnet
Access
To configure the DSU/CSU for SNMP or Telnet access,
H Enable the SNMP agent or Telnet server within the DSU/CSU (see
Appendix C,
Configuration Options ).
H
Select and configure the port that provides the link to the SNMP or Telnet
system.
H Set the Internet Protocol (IP) address and subnet mask needed to access the
DSU/CSU (see Appendix F,
IP Network Addressing Scenario ).
H
Select the link layer protocol (PPP or SLIP) for the port that provides the link
to the SNMP or Telnet system.
H For SNMP links, specify the two community names (and their access levels)
that are allowed to access the device’s Management Information Base (MIB)
(see Appendix C,
Configuration Options ).
H
For SNMP links, configure the device to send traps to the SNMP manager, if
desired (see Appendix C,
Configuration Options , and SNMP Traps in
Chapter 4, Maintenance).
H Specify the Telnet password or SNMP validation options, if desired (see
Appendix C,
Configuration Options ).
Configuration Examples
NOTE:
The following procedures are examples only. This chapter uses examples to
help you become familiar with the use of the asynchronous terminal for
DSU/CSU control.