beautypg.com

Snmp traps configuration options, C-31, Raps configuration options – Paradyne 3162 DSU/CSU User Manual

Page 119: Table c-15

background image

Configuration Options

C-31

3162-A2-GB20-30

March 1999

SNMP Traps Configuration Options

Table C-15.

SNMP Traps Configuration Options (1 of 3)

SNMP Traps: Disable
Enable Disable

Specifies whether SNMP trap messages are sent over the SNMP management link.

Enable – Enables sending SNMP trap messages from this unit over any SNMP
management link.

Disable – Disables sending SNMP trap messages from this unit over any SNMP
management link.

Number of Trap Managers: 1
1 2 3 4 5 6

Specifies the number of SNMP trap managers that are to receive traps for this unit.

NOTE:

You must configure an IP address for each trap manager that is to receive
trap messages.

NMS

n IP Address: Text Field

Text Field Clear

Specifies the IP address for each trap manager. This configuration option is repeated for
all trap managers supported by the unit.

Text Field – Allows you to edit or display the IP address for Trap Manager n.

Clear – Allows you to clear the IP address for Trap Manager

n. The IP address is set to

000.000.000.000.

Destination: None
None Com Aux FDL EDL1 EDL2

Specifies the network destination for Trap Manager

n. This configuration option is

displayed for the number of trap managers (

n) specified by the Number of Trap

Managers configuration option.

None – No Trap Manager

n network destination. Traps are discarded.

Com – The Trap Manager

n network destination is the communication port. This

selection only appears if the Port Use configuration option is set to Mgmt or Daisy.

Aux – The Trap Manager

n network destination is the auxiliary port. This selection only

appears if the Port Use configuration option is set to Mgmt or Daisy.

FDL – The Trap Manager

n network destination is the FDL management link. This

selection only appears if the FDL management link is enabled.

EDL

n – The Trap Manager n network destination is the EDLn port (where n is 1 or 2).

This selection only appears if the synchronous data port’s EDL management link is
enabled.

NOTE:

If the chosen destination link is disabled or down, the traps are discarded.
Choose another destination.