Planet Technology MH-2001 - Manual (Page 293)

MH-2001 Multi-Homing Security Gateway User’s Manual
9.5 Status
In this section, the device displays the status information about MH-2001. Status will display the network
information from the Configuration menu. The Administrator may also use Status to check the DHCP lease
time and MAC addresses for computers connected to MH-2001.
The users can know the connection status in Status. For example: LAN IP, WAN IP, Subnet Netmask, Default
Gateway, DNS Server Connection, and its IP…etc.
„ Interface: Display all of the current Interface status of the MH-2001
„ Authentication: The Authentication information of MH-2001
„ ARP Table: Record all the ARP that connect to the MH-2001
„ DHCP Clients: Display the table of DHCP clients that are connected to the MH-2001.
9.5.1 Interface Status
STEP 1 . Enter Interface in Status function; it will list the setting for each Interface:
„ PPPoE Con. Time: The last time of the MH-2001 to be enabled
„ MAC Address: The MAC Address of the Interface
„ IP Address/ Netmask: The IP Address and its Netmask of the Interface
„ Rx Pkts, Err. Pkts: To display the received packets and error packets of the Interface
„ Tx Pkts, Err. Pkts: To display the sending packets and error packets of the Interface
„ Ping, WebUI: To display whether the users can Ping to the MH-2001 from the Interface or not; or
enter its WebUI
„ Forwarding Mode: The connection mode of the Interface
„ Connection Status: To display the connection status of WAN
„ DnS/ UpS Kbps: To display the Maximum DownStream/UpStream Bandwidth of that WAN (set
from Interface)
„ DnStream Alloca.: The distribution percentage of DownStream according to WAN traffic
„ UpStream Alloca.: The distribution percentage of UpStream according to WAN traffic
„ Default Gateway: To display the Gateway of WAN
„ DNS1: The DNS1 Server Address provided by ISP
„ DNS2: The DNS2 Server Address provided by ISP
- 287 -