Planet Technology MH-2001 - Manual (Page 287)

MH-2001 Multi-Homing Security Gateway User’s Manual
How to use Statistics
The Administrator can get the current network status from statistics, and use the information provided by
statistics as a basis to mange networks.
Define the required fields of Statistics:
Statistics Chart:
„ Y-Coordinate：Network Traffic（Kbytes/Sec）
„ X-Coordinate：Time（Hour/Minute）
Source IP, Destination IP, Service, and Action:
„ These fields record the original data of Policy. From the information above, the Administrator can know
which Policy is the Policy Statistics belonged to.
Time:
„ To detect the statistics by minutes, hours, days, months, or years.
Bits/sec, Bytes/sec, Utilization, Total:
„ The unit that used by Y-Coordinate, which the Administrator can change the unit of the Statistics Chart
here.
‹
Utilization：The percentage of the traffic of the Max. Bandwidth that System Manager set in
Interface function.
‹ Total: To consider the accumulative total traffic during a unit time as Y-Coordinate.
9.3.1 WAN Statistics
STEP 1 . Enter WAN in Statistics function, it will display all the statistics of Downstream/Upstream packets
and Downstream/Upstream record that pass WAN Interface.
WAN Statistics function
„ WAN: Select the WAN1, WAN2 or ALL WAN Interface which you want to monitor.
„ Time: To detect the statistics by minutes, hours, days, months, or years.
WAN Statistics is the additional function of WAN Interface. When enable WAN Interface, it will enable
WAN Statistics too.
- 281 -