Paradyne M/HDSL Standalone Termination Unit HOTWIRE 7986 - Manual (Page 86)

Configuration Option Tables
A-4 7986-A2-GB20-10 December 1998
G.703 Interface Options Menu
For G.703 Interface Options, refer to Table A-2. To access the G.703 Interface
Options screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
G.703
О ОО
main/config/G.703 Hotwire
Model: 7986
G.703 INTERFACE OPTIONS
Port Status: Enabled
Line Coding: HDB3
Line Framing: noCRC4
Time Slot 16: Signaling
Send (AIS) on Network Failure: Enable
Primary Clock Source: G703
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Save
Table A-2. G.703 Interface Options (1 of 2)
Port Status
Possible Settings: Enable, Disable
Default Setting: Enable
Determines if the port can be configured and used to receive and transmit data.
Enable – The port can be configured to transmit and receive data.
Disable – The port can not be configured and does not receive or transmit data. No
alarms or traps associated with the port will be generated. The LED associated with the
port is held in the OFF state
Line Coding Format
Possible Settings: AMI, HDB3
Default Setting: HDB3
Specifies the line coding format to be used by the G.703 interface.
AMI – Indicates the line coding format used by the G.703 interface is Alternate Mark
Inversion (AMI).
HDB3 – Indicates the line coding format used by the G.703 interface is HDB3.