beautypg.com

Health and status, Able 4-1, Health and status messages – Paradyne M/HDSL Standalone Termination Unit HOTWIRE 7986 User Manual

Page 47

background image

Monitoring the Unit

4-3

7986-A2-GB20-10

December 1998

Health and Status

The following messages can appear in the first column of the System and Test
Status screen. The highest priority Health and Status message also appears on
all ATI screens on the bottom right.

Table 4-1.

Health and Status Messages (1 of 2)

Message

What Message Indicates

What To Do

System Operational

There are no problems
detected.

LOS at Net, Pt 1

An LOS (Loss Of Signal)
condition has been
detected on the network
interface. No signal is
being received on Port 1,
possibly due to a local
network problem.

1. Verify that the network cable is

securely attached at both ends.

2. Contact network provider.

OOF at Net, Pt 1

An OOF (Out Of Frame)
condition has been
detected.

1. Check the Transmit Clock Source

configuration options. Do not set
both the local and remote unit to
Internal, External, or Loop timing.

2. Contact network provider.

LOF at G.703, Pt 1

An LOF (Loss Of Frame)
condition has been
detected on the G.703
interface.

1. Verify that the network cable is

securely attached at both ends.

2. Contact network provider.

AIS at G.703, Pt 1

An Alarm Indication Signal
(AIS) is being received by
the G.703 interface.

1. Check the Transmit Clock Source

configuration options. Do not set
both the local and remote unit to
Internal, External, or Loop timing.

2. Contact network provider.

EER at Net, Pt 1

An EER (Excessive Error
Rate) condition has been
detected on the network
interface at Port 1. The
condition is cleared when
the error rate falls below
the threshold value
currently configured.

Contact network provider.

EER at G.703, Pt 1

An EER (Excessive Error
Rate) condition has been
detected on the G.703
interface.

Contact network provider.

RAI (Remote Alarm
Indication) at G.703
interface, Pt 1

An Remote Alarm
Indication signal is being
received by the G.703
interface.

Contact network provider.

Net Margin
Threshold, Pt 1

The signal-to-noise margin
has exceeded the
configured threshold.

Contact network provider.