Paradyne M/HDSL Standalone Termination Unit HOTWIRE 7986 - Manual (Page 35)

Initial Startup and Configuration
3-9 7986-A2-GB20-10 December 1998
Switchpack Definitions
Manually change configuration options by moving Switchpack S1 DIP switches
on the card. Table 3-1 lists Switchpack S1 definitions.
Table 3-1. Switchpack S1 Definitions
Switch # . . . Allows you to . . . Default in Bold
1 Enable or disable Switchpacks S1 and S2.
OFF = Switchpacks Disabled
ON = Switchpacks Enabled
2 Control line termination.
OFF = 120 Ohm
ON = 75 Ohm
3 Select the unit’s primary timing source. Only valid for units configured
as LTU.
OFF = Internal Clock
ON = External Clock
4 Control the unit’s E1 line coding.
OFF = HDB3
ON = AMI
5 Not used
6 Enable CRC-4 monitoring.
OFF = Enable CRC-4
ON = Disable CRC-4 monitoring
7 Control whether Channel 16 contains signaling information or data.
OFF = Channel 16 is used for signaling
ON = Channel 16 is used for data
8 Not used