Running network tests – Paradyne M/HDSL Standalone Termination Unit HOTWIRE 7986 User Manual

Page 60

Testing

5-2

7986-A2-GB20-10

December 1998

Running Network Tests

Network tests require the participation of your network service provider. To
access the Network Tests screen, follow this menu selection sequence:

Main Menu

→

Test

→

Network & G.703 Tests

ООООООООООООООООООООООООО

main/test/network_G.703

Hotwire

Model: 7986

NETWORK & G.703 TESTS

Test

Command Status Results

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Local Loopbacks

Line Loopback:

Start Inactive 00:00:00

Repeater Loopback:

Start Inactive 00:00:00

DTE Loopback:

Start Inactive 00:00:00

Remote Loopbacks

Send Line Loopback: Down

Send Inactive 00:00:00

Pattern Tests

Send and Monitor 511

Stop Active hh:mm:ss - Errors 99999+

Ctrl-a to access these functions, ESC for previous menu

MainMenu

Exit

ResetMon

Use the Command column to start or stop a test. When the Status column
shows that a test is Inactive, Start is displayed; when a test is Active, Stop is
displayed. Position the cursor at the desired Start or Stop command and press
Enter.

Selecting a Stop command on the Network Tests screen or Abort All Tests from
the Test menu will not disrupt a network-initiated loopback.

The Results column displays the test duration.

When the Send and Monitor 511 test is active, ResetMon is available to reset the
error counter to zero.