Pioneer Multi Projection System RM-V1000NU - Manual (Page 96)

95
OPERATIONS • MAINTENANCE
Replacing the Bottom MPU
[1] Remove the rear cover B (eight screws) and rear cover C (six screws). (Fig. 5-5)
[2] Remove the mirror stay A (four screws) and engine support stay B (six screws) (Fig. 5-6) and remove the MPJ
stopper (four screws) (Fig. 5-7).
[3] Remove the styling of the wire connecting the mini signal section and lower the MPJ by more than 2 per-
sons.
Removing the Mini Signal Section
[1] Remove the bonnet (three screws). (Fig. 5-8)
[2] Remove the screws (four screws) while holding the mini signal section and pull it out (Fig. 5-9). Use a screw-
driver of less than 15 cm.
Handle the wires with extreme care.
(Fig.5-9) (Fig.5-8)
(Fig.5-5) (Fig.5-6)
(Fig.5-7)
Mirror stay A
Engine support stay B