Pioneer Multi Projection System RM-V1000NU - Manual (Page 92)

91
ADJUSTMENTS
[8] To return the convergence and white balance adjustment data to that at shipment:
1) Set the adjustment mode.
2) Press the 7 key.
Select [7. MEMORY READ/COPY].
3) Select the number from the SUB MENU.
1 key : The convergence and deflection adjustment data will return to that at shipment.
2 key : The white balance adjustment data will return to that at shipment.
[9] To copy the convergence adjustment data between memories:
1) Set the adjustment mode.
2) Press the 7 key.
Select [7. MEMORY READ/COPY].
3) Press the 4 key of the SUB MENU.
Select [4. CONV. MEMORY COPY].
4) Select the copy pattern (keys 1 to 6).
5) If the copy pattern number is correct, press the
0 key within 5 seconds. (If not, the copy pattern will
be displayed again.)
If the copy pattern number is wrong, press the
MAIN MENU key and repeat from step 2 again.
[10] Resetting the setting
1) Set the adjustment mode.
2) Press the 7 key.
Select [7. MEMORY READ/COPY].
3) Press the 3 key of the SUB MENU.
As a result, the following settings will be set.
• MULTI (Peripheral light amount correction)=ON • Baud rate=4800 bps • COLOR MODE=1
• TV SYSTEM=AUTO • VIDEO MUTE=OFF • COMBINATION=OFF
• Convergence memory
NTSC input (VIDEO, Y/C, RGB)=MEMO-1
PAL input (VIDEO, Y/C, RGB)=MEMO-2
The adjustments using the above settings can be performed very easily.
Example : When the baud rate of each MPJ is set to 2400 bps as they are not same.
1 Press the
ADJ IN
key. (To set the adjustment mode).
2 Press the 7 key (To select [7. MEMORY READ/COPY].)
3 Press the 3 key (As the SUB MENU is selected, 4800 bps will be selected automatically.)
• To set the baud rate to 4800 bps, proceed onto step 7.
4 Press the 6 key. (Returns to the main menu).
5 Press the 2 key (Select [2. OPERATION MODE]).
6 Press the 7 key (As the baud rate changes cyclically, 2400 bps is selected.)
7 Press the
ADJ OUT
key to select a baud rate.
The adjustment is completed.