Tint adjustment [tnt command – Pioneer Multi Projection System RM-V1000NU User Manual
Page 120
119
APPENDIX (MVP manual)
Tint Adjustment [TNT command]
Input :
TNTd
1
d
2
d
3
Explanation:
Corrects the tint of the NTSC input board.
d
1
d
2
d
3
: Compensation value 0 to 255
TNT?
: Help display
TNT
: Displays the current value and moves to the sub command mode
• To execute this command, it is necessary to set the adjustment mode by AJYB. (Refer to the
AJYB command.)
• If data input is skipped, the sub command input mode is set after the data is displayed.
The sub command mode is the same as with the COL command.
• The changed value is memorized the last.
(Example) TNT
Indicates the current tint value.
128
Controls the Panel Switch Function
To Set the Manual Mode [MNL command]
To Set the Remote Mode [RMT command]
Input :
MNL
, RMT
Explanation : • Manual mode
: Makes the following switch functions effective.
1 GEN LOCK INT/EXT switch
2 Optional RGB board FILTER ON/OFF switch
3 VBS/ Y/C select switch
4 MODE switch (The RESET button is required.)
The manual mode is set at POWER ON (or RESET button).
• Remote mode
: Mode in which the above switching setting are selected via the RS-232C line.
In this case, the above switch states are ignored.
The settings which can be switched by the remote mode are as follows.
• External sync, internal sync switching
Refer to the EXT and INT commands
• Optional RGB board FILTER ON/OFF switching
Refer to the DSY and DSN commands (RMD-V3020)
• V IN (Composite video/YC separate) switching
Refer to the CIB and YIB commands.
• V OUT output format (MODE) switching
Refer to NT, NTR, NTD commands.