Pioneer Multi Projection System RM-V1000NU - Manual (Page 115)

114
APPENDIX (MVP manual)
To Store the Picture Frame Data [&W command]
Input : &W0, &W1
Explanation : &W0 : Sets the saved values to the settings at shipment.
(Load data using the &L command.)
&W1 : Saves the value adjusted.
• The parameters saved by the &W command are as follows.
• Picture frame data (Data changed by the &G command.)
• Screen start position data (Data changed by the &P2 command and &Q2 command.)
• Note : When this command is executed, the setting will be saved even if the power is turned off.
Therefore, all precious settings will be erased.
To Load the Picture Frame Data [&L command]
Input : &L0, &L1
Explanation : &L0 : Loads the picture frame data set at shipment on the RAM.
&L1 : Loads the picture frame data saved at the end on the RAM. (Data when power is turned on)
• The parameters loaded by the &L command are as follows.
• Picture frame data (Data changed by the &G command.)
• Screen start position data (Data changed by the &P2 command and &Q2 command.)
• Use this command to reference the adjustment data temporarily.