Pioneer Multi Projection System RM-V1000NU - Manual (Page 118)

117
APPENDIX (MVP manual)
*6 : Display of remote and manual states
REMOTE MODE : Remote state
MANUAL MODE : Manual state
*7 : Slot number
*8 : Type of input board
NTSC BOARD : NTSC input board
V.SCAN BOARD : Optional RGB input board
NO BOARD : No input board is incorporated
*9 : NTSC input board state
STANDARD MODE : When standard NTSC signal is input
NO STANDARD MODE : When non-standard NTSC signal is input
*10: Display of VBS/ Y/C select switch state
VBS : Composite video signal input (Indicates V FIL.ON for the V.SCAN BOARD)
Y/C : Y/C separation signal input (Indicates V FIL.OFF for the V.SCAN BOARD)
*11: Type of output board
4 OUT BOARD : 4 output board
NO BOARD : No output board is incorporated
To Perform NTSC Input Board Picture Quality Adjustment
To Set the Adjustment Mode [AJYB command]
To Exit the Adjustment Mode [AJN command]
Input: AJYB , AJN
Explanation: AJYB command : Sets the NTSC input board to the adjustment mode.
AJN command
: Exists the adjustment mode.
• When adjusting the NTSC input board, the adjustment command will be ignored if AJYB is not executed.
• To set the optional RGB board to the adjustment mode, use the :A command. (Refer to pages 121 and on-
wards.)