Pioneer Multi Projection System RM-V1000NU - Manual (Page 26)

25
INSTALLATION AND ASSEMBLY
4 Projection Screen
* Projection screen is double-packaged to maintain its performance. After removing the middle cover protect-
ing its screen, make sure the screen does not get scratched or dirty.
[1] Remove the top cover.
[2] Remove the band securing the middle cover and remove the middle cover.
[3] Gently peel off the black tape pasted at the four sides of the screen.
* Be careful not to damage the lenticular sheet.
[4] Take out the screen unit from the box and stand it on a flat floor, paying attention to its top and bottom.
[5] Remove the eight screws for transportation (gold), four protection panels and white sheet at the back of
the screen.
* The protection panel is attached with the transportation screws. Keep the removed panel if required.
When storing the system, do not remove the outermost protection panel.
[6] When opening the packagings of several units first, after opening them, place them in a different place to
protect them from damage, and place a sheet over them to protect them from dusts.
[5]
[3]
[2]
[4]
[1]
Black tape
Middle cover
(Fig.3-4)
Top cover
Band
Top
Right side
White sheet
Transportation screws (Eight : Gold)
Protection panel
Flat floor