Pioneer Multi Projection System RM-V1000NU - Manual (Page 106)

105
APPENDIX (MVP manual)
FG Frame Ground
Tx (D, I, O) Trandmitted Data
Rx (D, I, O) Received Data
RTS (I, O) Requenst to Send
CTS (I, O) Clear to Send
DSR (I, O) Data Set Ready
SG Signal Ground
1
14
25
13
Connection with External Computer
Straight RS-232C IN
FG 1 1 FG
TxD 2 2 Rxl
RxD 3 3 Txl
RTS 4 4 CTSl
CTS 5 5 RTSl
DSR 6 6 DSRl
SG 7 7 SG
*
* Pins 5 and 6 are short-circuited inside.
Pins not shown in the diagram are NC.
Signal name
CONNECTION WITH MVP EXTERNAL COMPUTER
• Refer to Chapter 4.(P.69) “External Control by MPJ RS-232C” for how to adjust the MPJ.
¶ Use a RS-232C straight cable.
¶ Refer to the following diagram for connections.
¶ MVP RS-232C Settings
Baud rate : 2400, 4800 , 9600, 19200
Bit number : 7, 8
Parity : NON , ODD, EVEN
Stop bit : 1 , 2
: Setting at shipment
This setting can be changed using the DIP switches on the panel.
Refer to “Chapter 2.(P.14) MVP panel 8 Baud rate switch”.