Pioneer Multi Projection System RM-V1000NU User Manual

Page 29

INSTALLATION AND ASSEMBLY

¶ When transporting or storing the units in the packaged state, always face them up.
¶ The number of units that can be stacked in storage is 16.
¶ As the screen is at the top, be careful not to step, and place heavy objects on this top side, nor hit it with sharp

objects.

¶ Do not mistake the top and bottom of the screen unit. The side with the longer screw projecting out (side with

transportation screw) is the top and the side with the 8 mm hole is the bottom.

¶ Before mounting the screen unit to this system, check that the transportation screw, protection panel, and

black tape have been removed. (Do not remove the protection panel on the outer-most side when installing
the system.)

¶ Also tighten the Mickey bolts used for connecting the unit and screen unit together using your hand. Tighten

as firmly as possible.

¶ Put on gloves when stacking the screen units for protection and perform in twos.
¶ To prevent the lenticular sheet from damage, mount the screen unit gently and do not subject it to vibration

and shock.

¶ When the screen units are stacked, the head of the panel fixing screws and 8 mm holes will engage. When

stacking the upper screen unit, make sure that it does not brush the lower screen unit as it has panel screws
projecting out.