Pioneer Multi Projection System RM-V1000NU - Manual (Page 139)

138
APPENDIX (MVP manual) CHECK SHEET
1. Preparations
1 Connect the power supply, and connect the cable for input signals and ABL link cable (control cable).
2 Place the connected cables neatly.
3 After completing the above 1 and 2, turn on the power and perform aging for one hour.
4 Prepare the signals required for adjustments.
2. Before Starting Adjustments (Set Conditions) .............................P. 36
1 Set whether to perform the adjustments using the remote control or personal computer.
2 Check the TV SYSTEM setting.
Check the convergence memory and white balance memory used for the adjustments.
3 Check and set the STATUS.
MULTI ON/OFF, COMBINATION ON/OFF, ABL link switch settings (3-levels).
4 Recording the settings in the memory.
3. Setting ID .........................................................................................P. 39
1 Set the ID to each CUBE.
(Note) The following IDs are provided at shipment.
4. Adjusting The Screen
1 Adjust the size of each screen. ................................................................................................................. P. 45
2 Adjust the convergence of each screen. .................................................................................................. P. 46
3 Adjust the link of each screen. ................................................................................................................ P. 103
4 Adjust the W/B of each screen. ................................................................................................................. P. 62
5 Adjust the ABL level. ................................................................................................................................. P. 66
6 Adjust the color using the image to be transmitted. .............................................................................. P. 67
7 Check the whole screen.
ID=11 ID=12
ID=13 ID=14