Pioneer DVR-LX60D - Manual (Page 141)

The Initial Setup menu
141
En
16
Additional information about the
TV system settings
About the input line system
This recorder is compatible with PAL,
SECAM, 3.58 NTSC and PAL-60 TV systems.
The Input Line System and Input Colour
System settings determine how the recorder
treats incoming video signals from an
external input.
Please note the following points when
changing the input line system:
• When the current input is a built-in tuner
channel preset, changing the input line
system will usually also affect the input
line system of the
AV2 (INPUT 1/
DECODER) input. However if the AV2/L1
In setting is set to Decoder , then the L2
input is affected instead.
• If, when the Input Line System setting is
changed, the screen goes blank (due to
incompatibility with your TV), you can
switch back by pressing and holding the
front panel
(Stop) button then
pressing INPUT SELECT (also front
panel) while the recorder is stopped.
• When you switch the Input Line System
setting the Copy List is erased. If you
switch the setting using the
(Stop)
button and INPUT SELECT buttons as
described above, there is no
confirmation, so please use with care.
• You can’t mix recordings of different TV
line systems on the same disc.
• When you change this setting, the Input
Colour System setting also changes
(see below).
About NTSC on PAL TV
Depending on the Input Line System setting
and the NTSC on PAL TV setting, the signal
format output when the recorder is stopped
varies as shown in the table below.
About the input colour system
The available options of the Input Colour
System setting depend on the Input Line
System setting. The table below shows the
different options available.
Additional information about
component video output
If you switch the Component Video Out
setting to
Progressive when using a TV that
is not compatible with progressive-scan
video, you will not be able to see anything
displayed on your TV. If this happens, press
and hold the
(Stop) button on the front
panel, then press OPEN/CLOSE . This will
set the recorder’s video output back to
Interlace.
Input Line
System NTSC on PAL
TV
Output
when
stopped
625 System Off PAL
On PAL
525 System Off NTSC
On PAL–60
Input Line
System Built-in
analog tuner External
input
625 System Auto Auto
PAL PAL
SECAM SECAM
525 System n/a Auto
3.58 NTSC
PAL–60
DVRLX60D_WV_EN.book 141 ページ ２００７年３月２６日 月曜日 午後１２時１６分