The initial setup menu – Pioneer DVR-LX60D User Manual
Page 131
The Initial Setup menu
131
En
16
Video In/Out
Input Colour
System
Next Screen
Proceed to the next screen to set the input colour
system for the external input and the built-in TV
tuner. Use the
Smart Jog
or
INPUT SELECT
buttons
to change the preset or external input. On the default
Auto
setting the recorder can generally correctly
detect whether the input signal is PAL, SECAM, 3.58
NTSC or PAL-60, but in some cases you may have to
set it manually if the picture is displayed incorrectly.
• Input Colour System cannot be set when the recorder is in D.TV mode.
• See also About the input colour system on page 141 for more information on this setting.
Component Video
Out
Interlace •
Select if your monitor/TV is not compatible with
progressive-scan video.
Progressive
Select if your monitor/TV is progressive-scan
compatible. Check the operating instructions that
came with your monitor/TV if you’re not sure.
•
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than
RGB
.
•
If your TV is incompatible with progressive scan video and you select
Progressive
, you will not be able to see any
picture at all. In this case, press
OPEN/CLOSE
while holding down the
(Stop) button on the front panel to
switch to
Interlace
(this also switches Screen Resolution on page 138 to the default setting).
•
When the HDMI signal is output, no video is output from the
COMPONENT VIDEO OUT
.
AV1 Out
Video •
Sets the
AV1 (RGB)-TV
SCART output to standard
composite video (compatible with all TVs).
S-Video
Sets the
AV1 (RGB)-TV
SCART output to S-video.
Recommended if you are using a long SCART cable.
RGB
Sets the
AV1 (RGB)-TV
SCART output to RGB. Good
quality but check your TV for compatibility. Note that
on this setting signals from the built-in tuner and
from external inputs is not output when the recorder
is in TV mode.
•
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case
either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 157).
•
The Component Video Out setting (see above) has no effect when AV1 Out is set to
RGB
.
•
When the HDMI signal is output, the AV1 Out outputs the composite video signal even when it is set to
RGB
.
Setting
Options
Explanation
DVRLX60D_WV_EN.book 131 ページ ２００７年３月２６日 月曜日 午後１２時１６分