Pioneer DVR-LX60D - Manual (Page 133)

The Initial Setup menu
133
En
16
DV Input Stereo 1 • Select to use the ‘live’ audio track (recorded during
the video shoot) from a camcorder that supports two
stereo audio tracks.
Stereo 2 Select to use the overdubbed audio track from a
camcorder that supports two stereo audio tracks.
Mix Select one of the three settings to use a mix of the
two stereo audio tracks.
Audio Out
Dolby Digital Out Dolby Digital • Output a Dolby Digital signal when a Dolby Digital
source is being played.
Dolby Digital
PCM
Convert Dolby Digital sources to Linear PCM output.
Use if your connected equipment doesn’t have a
Dolby Digital decoder.
DTS Out On • Output a DTS signal when a DTS source is being
played.
Off Switch off the digital output when a DTS source is
being played. Use when your connected equipment
doesn’t have a DTS decoder. In this case, use the
analog audio outputs.
96 kHz PCM Out 96 kHz 48 kHz • Convert 96 kHz digital audio sources to 48 kHz
output. Use if your connected equipment doesn’t
support 96 kHz sampling rate.
96 kHz Output 96 kHz digital audio when a 96 kHz source is
being played.
MPEG Out MPEG Output an MPEG audio signal when a source using
MPEG audio is being played.
MPEG PCM • Convert sources with MPEG audio to Linear PCM
output. Use if your connected equipment doesn’t
have an MPEG audio decoder.
Audio DRC On Switches on Audio DRC (Dynamic Range Control).
Use when listening to Dolby Digital material at low
volume.
Off • Switches off Audio DRC.
Audio DRC is not effective when listening via the digital output when the Dolby Digital Out setting is set to Dolby
Digital .
Setting Options Explanation
DVRLX60D_WV_EN.book 133 ページ ２００７年３月２６日 月曜日 午後１２時１６分